Chapters authored
Elimination of Acid Red 88 by Waste Product from the Phosphate Industry: Batch Design and Regeneration
Waste regenerated after washing of rock phosphate and phosphogypsum has been proposed as removal agents of Acid Red 88 (AR 88)) from artificially contaminated solution. Natural phosphate (PN) was also studied for comparison. These materials were characterized beforehand, as is intended for the removal tests, by chemical analysis, powder X-ray diffraction, Fourier-transform infrared spectroscopy, thermogravimetric analysis– differential thermal analysis, scanning electron microscopy, and N2 adsorption isotherms. The conducted experiments show that among the different materials, the PWR has the highest retention capacity of the dye (123.4 mg g−1) of AR-88. Upon calcinations, the removal capacities reduced by 60 to 70%. We take note also that a decrease in the amount of removed AR 88 dye occurs with an increase in pH. The kinetics data on the reaction between AR 88 and the materials are described well by a pseudo -second-order model. The Langmuir model is successfully applied to the experimental data of the removal of acid red 88. The removal process is exothermic.
Part of the book: Pathways and Challenges for Efficient Desalination
Ionic Conductivity of Strontium Fluoroapatites Co-doped with Lanthanides
Britholites derivatives of apatite’s that contain lanthanium and neodymium in the serial compounds Sr8La2−xNdx(PO4)4(SiO4)2F2 with 0 ≤ x ≤ 2 were subject of the present investigation. The solid state reaction was the route of preparing these materials. Several techniques were employed for the analysis and characterization of the synthesized powders. The chemical analysis results indicated that molar ratio Sr+La+NdP+Si was of about 1.67 value of a stoichiometric powder. The X-ray diffraction data showed single-phase apatites crystallizing in hexagonal structure with P63/m space group were successively obtained. Moreover, the substitution of lanthanium by neodymium in strontium phosphosilicated fluorapatite was total. This was confirmed by the a and c lattice parameters contraction when (x) varies coherently to the sizes of the two cations. The infrared spectroscopy and the 31P NMR (MAS) exhibited the characteristic bands of phosphosilicated fluorapatite. The pressureless sintering of the material achieved a maximum of 89% relative density. The sintered specimens indicated that the Nd content as well as the heating temperature affected the ionic conduction of the materials and the maximum was 1.73 × 10−6 S cm−1 obtained at 1052 K for x = 2.
Part of the book: Mineralogy